As a novice driver drove in a turn, remember: "One look, two slow, three passes"
Turning a car as a basic driving skill often puzzles beginners. Before the turn begins, you should enter the curve by the outside of the curve. When you reach the middle, you must rely on the inner side of the curve. After crossing the top of the curve, cut back to the outside of the curve, against the curve. The outer side of the road out of the curve, that is, when cornering to choose "outside - inside - outside" turn the route.
Take the T-junction as an example: How do the novices operate when turning?
1. When encountering a T-junction, be sure to slow down in advance to prevent the sudden emergence of cars from the left or right side of the road.
2. Observe the left rearview mirror at the same time to avoid the sudden appearance of the overtaking vehicle on the left, and you can further observe the interior rearview mirror.
3. At this time, the left turn signal should be turned on ahead of time. The purpose is to prompt the rear vehicle to make a left turn. If you turn right, the same reason.
4, when entering the intersection to slow down, first of all to see whether the left to the car, and then look at the right lane, if you do not have a car you can boldly move forward, if there is a car to stop and then drive the other vehicle in the past.
5, the completion of the turn, everything is so simple.
Road test corner turn
(I) Examination requirements: Use low-speed, prescribed driving routes, and stop at 90 degrees for a sharp turn through a right angle. If you can't turn a corner, you can use a reverse, but you must be deducted 10 points.
(B) scoring standards: wheel touch pressure highlights, fail; the wheel touches the tooth once, deducts 20 points; with a reverse, deducts 10 points.
(c) driving skills: First, a pass through, without the throttle. The second is to stick to the right side of the road as far as possible when entering the examination room. Third, once the road teeth in front of you are blocked by the hood, you must hit the left direction until you reach the end. The fourth is to look at the front of the exit and quickly return the direction.
Breathing Bag Mold,Porcelain Breathing Bag Mold,Breathing Bag Mould,Breathing Bag Mould
ZIBO HAOXIANG CERAMICS TECHNOLOGY CO.,LTD. , https://www.haoxiangceramics.com