Recently, Zhejiang Geely Automobile Co., Ltd. filed a recall plan with the General Administration of Quality Supervision, Inspection and Quarantine according to the requirements of the Regulations on the Management of Defective Automobile Product Recall and the Implementation Measures for the Management of Defective Automobile Product Recall, and decided to start from January 26, 2018. A total of 40,068 Bray GC-9 vehicles were produced during the period from April 1, 2015 to October 28, 2016.
Vehicles within this recall range, due to the problem of durable corrosion of the electric power steering harness harness connector pins, may cause some vehicles to report the fault code after long-term use. In extreme cases, the vehicle's electronic steering assist may fail, posing a safety hazard. Zhejiang Geely Automobile Co., Ltd. will install a rubber pad between the electric power steering gear housing and the motor involved in the vehicle for free, and apply grease to the wire harness terminal to eliminate safety hazards.
Zhejiang Geely Automobile Co., Ltd. will entrust Geely Automobile Special Service Station to notify the relevant owners through registered mail, telephone, SMS, etc., and ask the relevant owners to go to the nearest Geely Automobile Special Service Station for free maintenance. Users can call the customer service hotline 400-886-9888 via landline or mobile phone to get the information about this recall. Users can also visit the AQSIQ Defective Product Management Center website () and the WeChat public account (AQSIQDPAC) for more information. In addition, you can also call the AQSIQ Defective Product Management Center hotline to reflect problems during the implementation of the recall or to submit defects.
Gas Stove Parts is used in Gas Stove. The main components of the embedded stove are:
Structural parts: panel, bottom shell, this is a good understanding of the main structure.
Combustion system: fire cover, burner: the burner is usually cast iron or aluminum alloy. The primary air from the gas and the ejector enters from the burner and is initially mixed. Then it is mixed again through the fire cover and continuously sprayed from the fire hole of the fire cover. Out, forming a continuous combustion.
Ignition system: pulser, ignition porcelain needle: The pulse generator generates a high-voltage discharge device. The ignition ceramic needle (with wire) guides the high voltage generated by the pulser to the discharge position of the designated fire cover to ignite the gas.
Pneumatic control: valve body, air pipe: The valve body is to adjust the size of the flame, by adjusting the flow rate. The trachea is the passage of gas.
Other plastic parts: knobs, battery boxes, etc.
Partial seals: sealing strips, etc.
Gas Stove Parts
Burner Gas Stove,Stove Gas Burner,Gas Stove Parts,Gas Stove Burner Parts
CHANGXING BENNENG GAS APPLIANCE CO.,LTD , https://www.benngas.com